DEVICES FOR DIMENSIONAL ADJUSTMENT OF THE CUTTING OF LATHE MACHINES

Authors

  • Alisher Mamajonov Mamajonovich Ph.D.Professor Of The Department “Mechanical Engineering Technology” Tashkent State Technical University The Republic Of Uzbekistan. Tashkent
  • Buronov Mizrob Ikrom O`Gli Master Student Of The Department “Technology Of Mechanical Engineering” Tashkent State Technical University The Republic Of Uzbekistan. Tashkent

DOI:

https://doi.org/10.55640/eijmrms-02-10-19

Keywords:

Tools adjustment (setting), tool wear monitoring, measuring device, precision adjustment

Abstract

In this paper, the factors affecting the processing accuracy of lathes are examined. The paper highlights their environments, the dominant factors that have the greatest influence on the processing accuracy. The possibilities of increasing the processing accuracy on existing lathes by eliminating the influence of dominant factors on the processing accuracy is analyzed. The authors describes the place and value of the dimensional adjustment of the cutting edge of lathes while ensuring the accuracy of processing of parts such as a body of revolution, a method and a schematic diagram of a device for precision adjustment of the cutters of a lathe to the size to be machined are proposed in this paper.

References

V.V. Klepkov et al. Fundamentals of mechanical engineering technology. M.: INFRA-M, 2019.-526 p.

Alikulov D.E., Zhuraev M.A. The study of factors causing inaccuracy in setting the cutter to size // Proceedings of the Republican scientific and scientific-technical conference "Problems and prospects of innovative technology and technology", -Tashkent, April 14-16, 2019. -S. 59-60.

Downloads

Published

2022-10-19

How to Cite

Alisher Mamajonov Mamajonovich, & Buronov Mizrob Ikrom O`Gli. (2022). DEVICES FOR DIMENSIONAL ADJUSTMENT OF THE CUTTING OF LATHE MACHINES. European International Journal of Multidisciplinary Research and Management Studies, 2(10), 105–110. https://doi.org/10.55640/eijmrms-02-10-19

Issue

Vol. 2 No. 10 (2022): Volume - II Issue - X

Section

Engineering and Computer Science

Categories

License

Copyright (c) 2022 Alisher Mamajonov Mamajonovich, Buronov Mizrob Ikrom O`Gli

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Individual articles are published Open Access under the Creative Commons Licence: CC-BY 4.0.